Sawtooth Rifles Forend Insert SAWKET™ Rails: "JAE-700"™ side inserts
Sold as a pair, these SAWKET™ inserts replace the side rails in your compatible JAE-700™ chassis. These inserts were designed to allow mounting of up to four MDT™ chassis weights (two per side) as well as accept other M-LOK™ accessories.
Each pair of MDT™ weights adds 12.5 ounces to your rifle. MDT Weights are available here.
Installation Note: Fit in the chassis slots may vary. The insert slot dimensions can vary due to production era and amount of paint. While it is intended that these inserts will fill all the chassis (with side rails) out there, some fitting may be required in rare cases. If the inserts do not fit in the pockets easily, please call us to discuss options. DO NOT FORCE THE INSERTS INTO THE SLOTS OR USE THE SCREWS TO PULL THE INSERTS INTO A TIGHT FITTING SLOT. Screw torque should be finger tight with a screw driver. There is minimal thread engagement due to the thickness of the chassis in these locations. Over-torqueing the screws has the potential to strip threads out of the aluminum chassis frame. Blue Loctite can be used to keep screws from coming loose over time.
Design Note: Due to the placement of existing mounting hardware locations on the JAE-700, some SAWKET™ pockets are skipped in the spacing. This restricts the existing MDT™ weights to the locations shown below.
Material: 6061 T6551 Aluminum
Finish: Milspec Type III Hardcoat Anodize, Black
Thread Size for Hardware Compatibility: #10-24 screws that ship with most M-Lok accessories, T-Nuts are not needed